This is a used pedal. It has been tested and gone over by the experts at our shop to ensure it’s working properly and is free of issues, unless otherwise noted in this listing. Please see pictures provided and the notes below for condition and wear. It will be packed with care to be shipped to your door! If you have any questions about this or any other piece of gear we have, please let us know and we’ll be happy to help!
– Condition: 10/10
– Any wear of note: None! In mint condition with original box, power supply, user guide, sticker and rubber feet.
Effects Switcher for Voice or Instrument
Mic Preamp and Effect Loop
The Voco-Loco is a foot-controlled microphone preamp and effects loop switcher that enables a vocalist or acoustic instrumentalist to incorporate guitar effects pedals into their signal path.
Add guitar effects pedals to vocal or instrument mics
Create exciting and unique effects as you perform
Turn on multiple effects with one footswitch
Works with dynamic and condenser microphones
Connect any mic to your guitar pedals
The Voco-Loco combines a microphone preamp with a guitar pedal effects loop, allowing a lead vocalist, sax or trumpet player to add guitar pedals to their audio signal path just like an electric guitarist adds effects for soloing. Simply plug your mic into the Voco-Loco via the XLR input, connect your effects pedals using standard ¼” guitar cables, and then send the output from the Voco-Loco to the input on your mixer. Now with the touch of a footswitch you can add your favorite delay, reverb, distortion or wah-wah to any mic’d up instrument or vocal – the options are only limited by your imagination.
The Radial Voco-Loco is in fact a studio quality preamp that has been carefully disguised as a foot pedal! One look at the linear frequency response, exceptional signal handling and low noise and you will recognize the studio quality that is built-in. This ensures that the dry microphone signal will be delivered to the PA system without distortion or artefact and faithfully reproduce the instrument or vocal without compromise. A carefully crafted 2-band EQ makes adjusting the tone effortless. Turning on the effects loop adds transformer isolation to reduce hum and buzz caused by ground loops, a common problem that plagues many pedal setups. Once the loop is brought back, a tone control lets you tame the effects signal and a dry-wet mix control lets you balance the signal to suit.
*48 Volt Phantom Power
Although 48 volts is often specified, truth is, it is not always present or needed. In fact most condenser microphones are designed to work from 12 volts to 52 volts, many of which will also work on a simple 1.5 volt battery. The reason high voltage is used to charge condenser mics in PA systems is that in enables the condenser microphone to be positioned 200 meters (600 feet) away from the mixing console. Considering the Voco-Loco will likely be used near the musician with a 3 or 6 meter (10′ or 20′) mic cable, the high voltage is simply not needed. The Voco-Loco actually generates 40 volts phantom, not 48 volts. We chose to do this in order to reduce a power stage which could add noise. We have tested a wide range of popular stage and studio microphones and in all cases, the results were excellent.
Audio circuit type: Integrated Op-Amp with Class A FET input circuit
Frequency response: 20Hz ~ 20kHz
Dynamic range: 100dB
Clip Level: +15dBu
Total harmonic distortion: <0.005%
Intermodulation Distortion: <0.005%
Phase Deviation: 8° @50Hz
Input Impedance: 10K-Ohms, 100K (FX Loop)
Output Impedance: 300 Ohms, 3000 Ohms (FX Loop)
Common Mode Rejection Ratio: -73dB @55Hz
Equivalent Input Noise: -120dBu
Noise Floor: -85dBu
Maximum Input: +10dB
Input pad, 180° polarity reverse, Ground lift, Effects Loop
Input Connectors: XLR-F
Output Connectors: XLR-M
Construction: 14 gauge steel chassis and outer shell
Power: 400mA, center positive
Conditions: For use in dry locations only between 5°C and 40°C